Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Probably you are willing to create a 20 kW solar panel. For this you need to design a solar array which costs around $40,000. And which will generate around 65 kWH daily. Actual cost and units of generation will vary depending on your location and installation setting.
Arduino UNO can easily handle 20 mA current. Check this single page guide on their website: http://store.arduino.cc/usa/arduino-uno-rev3
As far as I know the internal resistance of Arduino is approximately 10 Mohms, so 0.486 uA current will be flowing in this case. I have not worked with...
I was surfing the impact of pole number on working of the machine (motors and generators). I studied machines for some time and familiar with equation N = 120f/ P. As it says increasing pole number will decrease the speed for same frequency. So is that all or there are some other factors too...
I uninstalled the Etap back so I'll not be able to accurately answer the problem. But the error indicates base limits. Just increase the base limit to 40%, in case it is 500 roll to 700. I hope it works. elseway i hope someone could better answer it.
There are bunch of circuits available in this regard. An example from Engineers garage: **broken link removed**. Don't rely on spoon feeding, 90% chances are you can't find a circuit custom designed for your application. Do search, modify the results for your case. That's simple, fair & square.
I'll suggest perusing research papers from IEEE & other Electrical journals. I am sharing an automatic meter reading paper from jee. Link: **broken link removed** This might serve a starting point for yous research. The more deep you'll go through research the fast will go acheive it. Get help...
yeah as I mentioned "Make your own lectures", If you find feasible try every circuit app shared by Catam.
One blink in my mind is Hyperphysics. . I hope it wil provide you ultimate resources for Grade 6-9 students, furthermore it'll be easy to start up with. Please check the Electricity and...
I just followed the thread, checked the comments and hope you'll find the solution from betwixt discussions. One piece I would suggest is to assemble the circuit prototype on breadboard (wheneever possible) for avoiding the prospective hassle.
Url for blog section should be title based
Recently I was reading a blog post Dimming lights at: https://www.edaboard.com/blog/2043/
The blog url makes no logic at sight, I checked many blogs and websites using example.com/blog/blog-title as their blog url. For example in present case it should...
I was searching for an LED sizing chart so as to select proper led sizing. Googling it provided an LED calculator from kitronik and a chart from oksolar. The calculator is amazing since it provides all details on 5mm, 3mm led. Quite good, but I am looking for some brief chart which mentions all...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
