Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi there, im now facing one problem which i need to doubling my output voltage to 10vDC -15vDC. As we know, the voltage from microcontroller only 5vDC. Is there any circuit or component i can use to doubled my output voltage. I have try one circuit which i will upload later. When simulate in...
thanks for the reply mister_rf. I try the circuit you modify and its still give the same result. i will try the link you give. am i using the correct igbt? thanks for the links.
---------- Post added at 11:29 ---------- Previous post was at 10:56 ----------
in your schematic the 2n3906...
Hi there, i m doing my Final year project on electronic load controller using igbt.. The problem im facing now is the igbt part which it suppose to chop off the Vce when there no voltage at igbt gate.. All i get is the Vce is always been chop to half of the input supply whenever there's voltage...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.