Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I wanna to implement an OpenBTS project on a ettus USRP boars
But I don't know waht's the differnrce between N & E series
and which one is the better for this project !?
And I want to know if there is another type of boards contains
DSP and FPGA processing capabilities than ettus research...
in many coding techniques, when we use a certain technique to minimize probability of error,
and plot the coded curve with the uncoded curve such that in this figure,
the uncoded performance is better in the start of analysis at small SNR,
but the performance of the coded one appears at high...
it is a square loop in centered in the original
for the positive Y
Ay=sin(k.*(l-abs(y))).*exp(1j.*k.*sqrt(y.^2+l.^2).*sin(theta).*cos(phi-atan(y/l)));
for the negative Y
Ay=-sin(k.*(l-abs(y))).*exp(1j.*k.*sqrt(y.^2+(l.^2)).*sin(theta).*cos(phi-atan(y/l)));
positive X...
I need a help in Writing a Matlab code that analyzes a square loop antenna with half-wavelength side and fed at the mid-point of one of the sides. Sinusoidal current distribution is assumed.
Code Output:
Radiation pattern in the loop plane (the XY plane).
Radiation pattern in any plane...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
