Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks again for your response.
A good thing about working for a small company is you get to design a little bit of everything. A bad thing about working for a small company is you get in over your head sometimes.
Looks like I have my work cut out for me on this one.
Thanks for your response
Push-pull to boost the DC. Then full wave bridge.
Each half of the Push pull boost on the primay is switching at 25KHz.
Primary CT is on one end of the transformer.
No CT on secondary.
Not sure how to go about designing something like this.
I am trying to design an inverter.
Vin 10-14VDC
Output 220VAC (modified sin wave)
50Hz
300W
I don't have any inverter design experience, so I swollowed my pride and tried to reverse engineer a few different automotive inverters. Most ot them where crap, but I did find one that seemed to be...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
