Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi all,
not long ago i finished my cnc mill, all works ok except one small problem
the dc servo motor has 3 wires, 2 for power and 1 frame ground
currently i have to run the motor with the frame ground disconnected, if frame ground is connected to wall plug ground and power supply frame then...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
