Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi everyone,
I'm working on SIMCOM5218E and have some trouble about it. I have designed a GUI on PC and communicate with my SIMCOM device. Normally I have communicate from PC to device and from device to PC. But nowadays I could not .
I'm sending client connection from PC to device, device...
Hi everyone ,
I m working on SIMCOM5218E module. I communicate TCP connection with GUI on PC. I have a static IP but can not declare it to Simcom5218E. How would I do that declaration ?
Has any idea about it?
Regards.
echoloji
Hi everyone,
I'm using BeagleBoard xM and SIM5218E WCDMA Board. I connect with microcom terminal to SIM5218 and using AT commands. Everything is OK.
I'm sending image from SIMCOM storage 'C:/Picture' to PC Host. That is OK . But I have some question about this topic.
I want to transmit an image...
Hi everyone,
I'm working on SIM5218E wcdma module but I have some trouble about serial communication. When I connect to serial cable and open cutecom , I only see "'p'p'p'p'p'p'p'p'p'p'p'p'p'p'p'p'p'p'" this datas. So I can't do anything. I'm sending AT command but I can't recieve any answer...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.