Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I have deigned a pcb which includes an SMA connector and 3g module. I'm a novice in RF field. The RF trace width that i Have calculated for 50 ohm impedance is 0.427mm.(core thickness=0.27mm and pp=0.076mm). I need to get my gerber verified before sending it to manufacturer. I've attached my...
I 'm new to Multi layer PCB design.I am designing a PCB with 4 layers in Altium . the stack up is Layer1= S1, layer2=GND, layer3=POWER ,layer4=S2. I'm confused as how to route the power tracks(VCC,Vbat etc) in the third layer , since its an internal plane layer(negative plane).Should i create a...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
