Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I think these theories are general. So you can use them in any freq. range. The feedback is more offen in schols, but in my opinion negative resistance is more practical.
Regrads.
eblue
nokia rs232 circuit
Hi,
I bought Mbus/Fbus cable several years ago for 5 EUR. Before making your own try to find one for your Nokia. It has built in level shifter that takes current (power) from the computer's RS-232 port.
The Mbus protocol alows only 9600 bit/s. If you use Fbus you can set...
Hi,
in Matlab documentation they say to use this p-file to hide the algorithms in original m-file. You could look a litle bit more to see if there is some info on p-file format.
Without the format you can't expect to see what is inside.
I am not optimistic on this.
regards.
eblue
latex block diagram software
Hi,
even Word or Excel could help you to do the block diagrams. Did you try them?
For schematic I prefere EDA like OrCAD or LTSpice (free).
My waveform favorite is MATLAB.
Regards.
eblue
Fundamental mode is basic mode of oscillation. It's freq. is 1*f. Overtone modes are roughly odd multiplies of this frequency 3*f, 5*f, ...
Find more at:
https://www.corningfrequency.com/library.htm
Regards,
eblue
difference between oscillator and crystal
Oscillator is a circuit that oscillates. There are many types of it.
We can say that crystal (usualy quartz crystal) is used to make the oscillations of oscillator very accurate. This oscillators are called crystal oscillators.
Hope this helps.
eblue
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.