Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: CAN I USE RELAY
One engineer here uses a PIC for this sort of thing. I prefer the 555 timer. Hold the reset line low until AC power is lost, then let it go high. Set the RC for your 20s delay. Use a small NPN transisitor off the output to drive your relay. Good luck.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
