Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
radial stud design
Why don't you just simulate on your substrate:
input, short 50 Ohms-Line, T, same 50 ohms-line, output
on the T you put your radial Stub and vary angle and length.
Watch S11 or S21 and watch what angle, radius is best.
If you vary the angle, then length has to be altered...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
