Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello all, I am creating a Pcb with Altium Dxp for the first time.
Simple issue: The default clearance rule on the board specifies 8mil. See here:
This is fine for everything on the board except for some nets which will carry higher voltage, for which I would like to set the clearance to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
