Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
kindly Help,
I had put LPC2148 in power down mode. resuming from PD was done via EINT0,EINT3 and BOD.
It is on battery operated instrument. when batt goes below 2.9V it brings uC out of PD mode but does not have enough time till 2.6V as wake up timer needs time. now if my uC is not in reset mode...
Hello everyone!!!
I m using DAC in LPC2148 ARM7. Here Pin 9 has been connected to resister divider network. this divided potential is fed to op-amp. now when i write a value in DACR resister o/p on pin 9 is shown acc to the value written with respect to VREF. but when i rewrite the value in DACR...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
