Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I have Thinget XC3-60R-C PLC, I need PID programming help-
In XCP-Pro PID config have Target Value (50 in D20), Measured Value (60 in D21), Parameter and Output (100 at Y21). what should I set Parameter value?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
