Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I have connected the motor to the sensor as shown in the above diagram. I also connected an 40w luminescent bulb to the sensor, it also showed 2.5V at the output.
The motor is 1.5W-2.5W with voltage rating of 230V.
The value of 2.5 V is obtained at the output pin of the sensor.
As per the datasheet, 2.5 V is obtained when there is no current passing through the sensor. So I suppose the sensor is not getting current even when the motor is on.
I have connected the sensor in series with the load with the...
Hello,
I am trying to measure ac current flowing through an ac motor using hall effect current sensor ACS712 with maximum current rating of 5A.
The sensor is interfaced to the raspberry pi through an ADC in series with the motor.
The problem I am facing is everytime I get 2.5V from the output...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
