Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
As it's ECO flow, I am already routing with timing disabled. Redesign is not an option as the design is already at final stage.
Also I am trying to route after removing the fillers and metal fill.
Are there any other techniques or ICC commands I can try to clean these shorts ?
I have rolled-in a ECO to fix timing in a slightly congested design. Before rolling-in the timing fix ECO the design was almost DRC route clean.
After rolling-in the ECO, I have about 100 routing shorts which are difficult to clean in ICC. I have tried deleting the nets and routing again but it...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
