Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I am designing a rotator circuit which consists of a 5v stepper motor and 5v DRV8834 driver IC. The driver IC got 1 pins which is a step to control the motor. The problem/question is that only a two lines come from the camera top section(combined 12Vpower/5V step line and ground. The camera top...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
