Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I asked to my advisor and he said yeah you can do this but instead of it , give 5A by using 12 pins and dont combine them in a node , just route 12 traces from 1 to 1 , 3 to 3 , and so on . And I did that . So basically all of my traces carry like 0.47 to 0.5A .
Since the traces are perfecly...
So , for example for 5A , should I use 12 pins and combine them in a node then split to another 12 pin of the other connector to transfer that current ?
I read these books(not entirely) but it gives no idea about how to apply these ideas in Altium .
The connectors that I am using are :
https://www.molex.com/molex/products/datasheet.jsp?part=active/0541325097_FFC_FPC_CONNECTORS.xml
In the schematic I put the connectors at two ends of the...
Hello nation , I'm currently doing my summer practice and my advisor wanted me to build a flexible flat connector to serve as board to board wiring . He wanted me to use Altium which I had no idea about . I found some Molex FFC connectors and libraries of them which include 3D model also , but I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
