Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi forum,
For simulating a device, the definition of dielectric (or dielectric anisotropy) is very important. Especially if u got vertical or lateral device.
So I got stuck at the definition of the dielectric in ATLAS. The manual says:
This means what exactly?
How are the x,y,z axes defined...
Im sorry, I do not know how the parallel diff pair can achieve common input from 0.5 to 2.5 volt, since for me the problem of Vt<Vin,min(0.5V) still remains. I tried to find information about the parallel configuration and how its works but found only these :
In Bakers book p.736
**broken link...
Thx to all for your suggestions. My problem still relies in the parallel diff. amp. (avoiding folded version). Actually trying to figure out how this is working, not finding much on the p.diff amp. Keep trying tho. If someone has some tuts on that, i would be grateful. Thx again.
Hi to all!
This my fisrt post!
I got a problem with the specifications of an op-amp. I think i dont understand basic stuff. I should design an op-amp (my first attempt!) with vdd=3V and
gain about 4000 (>70db)
Common mode range 0.5-2.5V
Output 0.5-2.5V
I picked the Miller amp as...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
