Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I have a motorola IAP6300/7300 and would like to configure to support at least 4 wireless broadband network. Anyone with supporting tech documents to share? What is the configuration that I need to change for the IAP?
Will I be able to see the adhoc loss for each path? (Because I...
The existence of bandwidth at 3dB indicate the transmission lines is too lossy and that the resonator do not produce a good resonating frequency or is the normal bandwidth of a resonator?
Hi,
I have attached my circuit layout for better reference. Operating freq to be set at 2.45GHz. However, my simulation results only give s11=-3.2~3.4dB and s22=-5.4~5.6dB. Layout 1 shows the circuit for the simulation. What can I do to improve the readings?
The interdigital is 8.7mm by 5.7mm...
I doubt so. I was thinking if it is the resonator circuit that is causing the poor results. I have a interdigital cap and a meander line inductor linked to the lower ground plane. Could this be causing a mismatch?
Hi,
Im using CPW transmission lines for my resonator. Both port 1 and 2 are matched to 50ohms. However I got very poor results for my s11. Does anyone knows the problem?
Hi,
Is there any formulas to calculate the value of a Interdigital Capacitor and a Meander Line inductor?
Or does anyone knows how to extract the parameters of these two structures using ADS?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
