Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
recently，when simulating the structure of spiral inductor with NI core，faced the
problem about mesh or port.the error in detail： [error] Port refinement, process abc3d: Port LumpPort1 with terminals will not support terminal mode(s). Most likely causes are: Incorrect boundary setup...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
