Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I have a receiver for spread spectrum signal which must receive a signal ~10dB below the noise floor. I am trying to establish the bare minimum gain from the RX input to the ADC converter input. For a non-spread-spectrum signal, I would normally provide enough gain to place the noise floor at...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
