Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
yes, Surface mount pads. I am creating a PCB. My problem is that I need to place individual pads on both the top and bottom layers. the 2 need to remain seperate however
I have placed rectangles in layer 17 for pads that I ONLY need on the top layer. I have more pads that I need on the bottom layer. If I place them all in layer 17, then my gerber files will be messed up when I select them. Do you have any advice on how to get pads on top OR bottom layers?
Re: ExpressPCB HELP!
Okay, thank you so much. I emailed them at support@expresspcb.com and am awaiting a response
Added after 58 minutes:
ExpressPCB does not allow any additional hole sizes than those offered inside the program itself. If you want a hole size that they do not offer, I...
I am using ExpressPCB and need to have a hole drilled that is .360" in diameter. Express PCB largest hole is .251". Is there anyway that I can have my hole drilled? I would personally drill it but my board is a 4 layer board and I am scared I will short the inner power and ground planes, which I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.