Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I made a custom footprint for an 8 pin TSSOP IC. Each of the four pins on a side are 0.3mm wide and 0.5mm apart (BSC). In the .dra file everything looks right. However, when I add the components into a .brd file, the pins have a couple issues. On both sides, the two middle pins are 0.6mm away...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
