Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi ,
you asked of the voltage i wanted to measure .. which i said is 220v, you also asked of isolation measuremnt whic is yes... i want it to be isolated cause i will like to power the pic through a battery of 24v.
i dont want any othe information apart from the pic showing only the voltages of...
thanks for the responses.. pls can u help with the link to the site, i av searched but havnt seen one with pic that why i put these here. thanks........ the voltage i want to measure is 220v
- - - Updated - - -
thanks for the responses .. pls i have search and i havent seen any..pls help me...
i have attached the picture . i have experience about high voltage .. but in this i want to know the voltage from each line , that is why every of my line will have its own transformer and the voltage i want to measure is 220v . thanks for your responses ..i appreciate
Hi everyone,
pls i need help on this project
i need to measure the voltage from each line and and the phase angle also will be able to select the one with higest voltage to on the load and if they are all the same voltage not less than 180 , the controller should choose any one itself.. i...
Re: keypad in flow code pic 16877a
mickro c thats what am using i want to put in keypad that can control the flow like amount if it is pressed with the keypad
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.