Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi everyone,
I would like simulating the S-parameters for a rod choke in the frequency range 0.5-300 MHz.
Which simulator, boundaries and port type shall I use? And how can one extract values of L and Cstray?
Thank you.
Hello,
is it correct positioning a waveguide port after vias, like in the picture attached?
I know how to create a waveguide port starting from a PCB trace (like in pic_3), but I have no idea how to start in this case.
Thank you.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.