Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
When running stb analysis, I would like to see the bode response not just for the entire loop but for some intermediate nodes to figure out how much gain/phase each stage in the loop is giving me. I have not been able to find how to do this in Cadence ADE.
The answer depends on a lot of things:
1. Are you planning to use only one of the ir2101 outputs (HI or LO). You can do this but your efficiency will be impacted
2. How fast do you intend to clock the converter? Just make sure the delay of the gate driver is short enough for you
3. It looks like...
Got it. Thanks!
Now I have two more questions:
1. How do you generate multiple curves for the initial C value parametric sweep? (i.e. if I want to sweep another variable and see what effect it has on the C)?
If I put another variable in the parametric control thingy I get two separate plots...
How do you perform parametric analysis in Virtuoso? I only see DC analysis, so I sweep the parameter I want. However if I evaluate the OP() statement I only get one value that is the one associated with the single DC operating point set by the components, not the sweep from the DC analysis. Any...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
