Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks, I already red some ANs (not this one,thanks again) from microchip but I would like so much to avoid the test-and-modify phase.
In the current project, the one shown in the movie, I used a QT1106 device from Quantum, now Atmel. Pretty simple to implement in dry conditions.
I hoped to...
Some times ago I developed a touch sensing wheel that works pretty well in dry enviroments.
You can see a picture and a small video:
Unluckly it was suppose to work in very wet conditions... and it didn't work, so I stopped the development.
Now I'd like to restart the project.
My...
Thanks for the fast reply,
it seems what I need, I use to buy a lot from Farnell but I never checked :oops:
Just two points:
- Unluckly the datasheet link seems broken (but I'll try starting from the manufacturer).
- Is it overpriced ? A rought calculation tell me it will cost 4-5€ per...
That was an old project I did a couple years ago:
A short video (sorry for the low quality):
https://youtu.be/6P0OKhac51g
It was suppose to be an electronic hand-shower, it worked but it never moved from the test stage.
The OLED display (96x64) is controlled by a PIC18F4525 programmed in...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
