Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi, The issue are these>.. I used a PIN diode tomake a phase shifter obtaining a 90 degrees phase shift.Now I have been told by my supervisor to tune using stubs. I have read in Pozar and Fooks how to do it.But I am thinking about it in this way. Since Double stubs tuning is used when the load...
Hi,
Im designing a phase shifter with PIN diodes. Now i have to enhance the bandwidth at which switching can be done...what methods can i use and can you help me out!!!
Hello ,
How can I design a phase shifter in MIcrowave Office. I am to use RT/Duroid as the dielectric...could anyone help with leads of the schematics....i knowi am to use 2 SPDT's at either ends of the transmission lines...it is to operate at 5GHz and have a phase shift of 45 degrees.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
