Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
In my circuit, port1 is connected to the gate of a 2 fingers nmos.
So I want to get all of the resistances from port1 to the gate.
Does that mean I need to calculate the total resistance by myself?
I found P2P resistance in RVE, but I am not sure if it works correctly for port1 to the instance pins.
Hi,
I am running calibre PEX for parasitic extraction, I want to extract R+C+CC and the output format is Hspice
After finishing PEX, I look into the file about the parasitic resistances, there are many resistors show like:
.subckt XXXX%port1 1 3
r1 1 2 10
r2 2 3 5
Is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
