Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
:?:
It's said port characteristic impedance can be defined only on cross section parameters, isn't it?
But, my practice says no.
Any one can help me?
:arrow:
HFSS 10.0
microstrip: PP thickness 4.2mil, Er=4.1;
Trace width 5mil.
discontinuaty: trace with 20mil-width.
distance from...
to get a wide band terminal s-parameter model (only include TEM mode).
do I need to adjust port size for different frequency range, then combine these result together?
Because wider port size may introduce higher mode, e.g. TE10....
Compared with CST,
what kind of object is suitable for being simulated by HFSS?
what kind of question is suitable for being simulated by HFSS?
Compared with HFSS,
what kind of object is suitable for being simulated by CST?
what kind of question is suitable for being simulated by CST...
How to get desired TEM field pattern with 3 or more conductors?
I draw modal/terminal line between the 2 conductors.
When I plot the E field pattern of the waveport,
I find, sometimes, HFSS treat the last conductor as floating,
and sometimes, sig/gnd.
How to control...
Re: HFSS mesh problem
Thanks!
Menuitems of HFSS\mesh operations\.. are not what I want to discuss here..
I have tried below actions:
1. Adding a point object on the surface of the object I want to mesh.
The point can't be a model object. It doen't works.
2. Draw a sheet (e.g. rectangle)...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
