Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi. I've worked with AVR family and At91sam7x256,and now I want to start learning ARM9 & ARM11.how can I start?I've just worked with C and I don't know the other language.so please helpe me to know what i need to know ,to start learning.
hi. simply you can set the left I/O as out put and set the right hand I/O as in put, after that if the right I/O was High when you set left I/O as 1 ,the switch is close and if no the switch is open.
I want to make a project which when I push the number 7 on the phone , lcd show the number 7.this project should be do with MT8888,Atmega32 and lcd .please help me to do this project .
hi.there are lot of points which you should care about them.some of devise are on board and you cant upgrade them and some of new devise cant config with the old motherboard.
thank you.the pdf is what I need.so its better to connect the Reset pin with a 330 ohm resistor to the ground even I don't need the external reset in my circuit ?
what shoud I do with AVCC & RESET pins in AVR?
hi.I want design PCB for my circuit which its has a ATmega 16.I heard that I should pull-up the AVCC pin to protect it from noise.is it true what I heard or no.and my another question is that when I want update my schematic to pcb in altium...
Re: How to start learning electronics better?
hi.i think the best way is to learning by exam.I mean that when ever you read s.th about an element you should make a simple circuit by that .in this way you can get a lot of points about that which you cant learn them in theory.you can use...
Hi.I want to make a musical Fountain which can be flexible with light.so is there any good article to help me ? whats your idea about the motor and the controller ,most of the sample which I search ,was made by PLC so is there any idea about making musical Fountain by PIC or AVR?
Best regard
Re: how to learn analog circuit design..
hi.I think the best way is learning by example.you can find a simple circuit and after that read an analyses about each element of that circuit.in this whey you learn practically.
sorry for my mistake.yes as betwixt said I want to use mechanical potential to turn on the LED.So is there any other idea to help me to do this project?
hi.I want to turn on an LED without using battery.and I want to put it in Yoyo . in fact I want to use manically potential to turn on the LED.pleas help me to do this
hi.I want to know whats the advantage and disadvantage of bascom AVR and I want to compare it with C.and which one its better for programming the AVR micro controllers.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.