Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
no, here Vcc= 12V, i'm giving 12V dc power supply in the driver IR2112 , i'm getting amplified voltage of 10V in pin 1, not in pin 7 , but there should be two square or PWM signal in pin 1 and pin 7, that's the main problem here
i'm designing a sine inverter using pic16F877A, i'm getting the PWM signal properly , two square wave of 50 Hz and two SPWM of 1kHz, but when i feed these four signals into the MOSFET driver IR2112 , i get one output from pin 1 , not getting any signal from pin 7 after giving two inputs in pin...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
