Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
help me with my code and my circuit.i made a linear robot,,,it will grip then slide to opposite position then go back to its original position..
the problem is the stepper motor i used did not work properly..it only vibrate
here is the code
here is the code:
clear
ti var byte
c var byte
z...
i am using this motor for our linear robot..it only pick then slide to opposite side then drop and back to original position...
why if i reduce the delay time why is it that the motor only vibrate?
the code i showed before, i think there is something wrong..when i connect the circuit to the stepper..it only vibrate...
---------- Post added at 18:17 ---------- Previous post was at 18:16 ----------
the picture of stepper in the link is the one i am using
thank you for your help i already run my mcu well..but i have question..do you have an idea what are the parameters to run a 5 and 1/4 floppy stepper motor?
thank you for your help and guide...
---------- Post added at 07:21 ---------- Previous post was at 07:19 ----------
i can i post the setup?the circuit design only or i will take picture of my actual design?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
