Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
you may want to try this ... if the distance between the inner radius and the outer radius (of your coaxial) is less than 1/10 of the wavelength
Draw the inner conductor on top of the ground plane ... but "do" leave a small gap between the ground and the inner conductor ... then draw a...
Hi:
I drawed a 1-port equivalent circuit model which has lumped L and C parameters and a microstrip for an antenna structure using ADS. I measured the S11 using Network Analyzer. I know the desired length and width of the microstip and I like to optimize the L and C values to curve-fit the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
