Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thank you for your reply. I have realised these improvements, and did some changes as to address the registers (K5).
A soft(ware) reset is possible via the µC.
As !MCLR is a 5 V tolerant pin this is ok, I think. If you don´t build an OTG device you don´t need them.
Improved plan is attached.
Hi all,
I want to build an adapter for a 3.5" floppy disk drive. I intend on using the WD37C65 as floppy disk controller and the PIC32MX250F256H as microcontroller. I did already the circuit and wanted to hear your opinion on it. I know there are USB floppys for 20$. This is intended as a...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.