Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I have a pic16f887 microcontroller and four types of sensors (temperature sensor , smoke sensor, ping, and motion sensor) connected to it to detect intrusion and fire i need to detect any incident and send at command to the gsm to call the police and play a recorded voice to alarm for the...
i am using a temperature sensor that use one wire communication so i need to connect it to a microcontroller and the temperature sensor read temperature in a do loop and inside i have an if statement to check if temperature is greater than 28 it sends a message using the gsm to the user but as...
Hello,
I am new to mikroc and i have a project to detect intrusion and fire and send alarm through gsm to any number i did that but for temperature sensor if it is higher than a 28 for example it sends an alarm message but whenever it is at this temperature or above it keeps sending the message...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
