Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
thankyou.now i know three soft can do this now:1,p-cad2006 2,diptrace 3,altium designer 2009.
pcad2006 and diptrace is default to use the "slashed zero"
in ad 2009 you must change font.
can anyone tell me how to change my silk font type to like in this picture?
the zero is very special in this pcb.
i can use protel or allegro or orcad or pads.
MY LCD DRIVE IC IS ST7920:
AND HERE ST7920'S DATASHEET
**broken link removed**
MY CODE AS BELOW: DISPLAY NOTHING ON LCD
#include <p33fj16gs504.h>
#include<spi.h>
_FWDT(FWDTEN_OFF)//7.37MHZ
//lcd2232F Serial interface(ST7920)
#define uint unsigned int
#define uchar unsigned char
void...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
