Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
The error is:
@E: CG165 :"E:\verilog\new\cqpic100d\PIC100D\VERILOG\DATARAM.V":27:10:27:22|Illegal defparam. parameter LPM_WIDTHAD cannot be found in module lpm_ram_dq.
the source code of verilog:
module dataram(addr, read, write, clk, datain, dataout);
input [8:0] addr;
input read;
input...
a transmitter ic & a receiver ic all bulit with one 8 bit risc mcu, the transtmitter is ok ,but the receiver ic test and produce all ok ,but when the product move one place to other place , the receiver is not work, oscilliter is ok ,it seems the mcu not work, what problem?
In the lcd system,use 1.5v (vdd) battery,to show lcd i need to generate -1.5v(vee) source.
The lcd is 2 bias,3 com 7segment, the com need 1.5v 0v -1.5v total three voltage,I supply 1.5v through a pmos,the substrate connet 1.5v;send -1.5v by a nmos,the nmos substrate connet -1.5v;but i sent 0v...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.