Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by cliffj

  1. C

    mixed signal design layouts guide lines

    The art of Analog Layout , I think you can find many great guide lines in this book
  2. C

    EE240 lecture notes UC Berkeley

    Part of the lectures
  3. C

    EE240 lecture notes UC Berkeley

    Part of the lectures
  4. C

    EE240 lecture notes UC Berkeley

    FYI
  5. C

    what's settling time?

    Time for your opamp to settle down within a specified output range(accuracy), usually within 0.1% error. You can refer to the attached document
  6. C

    How to size the transistors in an opamp

    Please refer to the attached file ~
  7. C

    Looking for Jiyi Gu's MA thesis about SDM

    Could anybody help to upload this SDM master thesis ? Jiyi Gu, Design of a Digital Audio Sigma Delta Modulator in 0.18um CMOS University of Windsor, 2002 Thx
  8. C

    EE240 lecture notes UC Berkeley

    Just goole EE240 and you can fine the website to download the lectures
  9. C

    Parameters for good Monte Carlo simulation

    Re: monte carlo Since we care much on the threshold mismatch for MOS, you can vary the oxide thickness(tox), nch(doping concentration), dw, dl , dvth0 etc...
  10. C

    What is the usage of source follower?

    Level shit and buffer ( high impedance input and low impedance output)
  11. C

    CADENCE simulation for different temperature of parts

    I don't think spectre can do that. I think you can run your circuit twice and use the dc result from 1st temperature to simulte your circuit uner 2nd temp. and 1st dc.
  12. C

    Comparison of two stage opamp and folded cascode opamp.

    two stage opamp architecture Better ICMR in folded cascode. Better open loop gain in two stage opamp design.
  13. C

    How to simulation input reference Noise ?

    .ac and .noise analysis, and print the noise voltage at the node you want to check.
  14. C

    [SOLVED] how to measure the input capacitor of opamp?

    Try Agilent 4284 or any network analyzer. But it depends the freq. range you wanna analyze.
  15. C

    how to design a zero offset opamp?

    opamp offset There is no zero offset. Try chopper, auto zero, technique etc ....
See more

Part and Inventory Search

Back
Top