Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I am sure that broadcom, atheros, marvell all have them. The problem is they don't come in a development board, and if they do, the documentation and drivers are very difficult to obtain. Thanks anyway.
I need the data sheet or any documentation related to configuring and programming the 88W8686. Can anyone please help? I will greatly appreciate your effort.
802.11 spi
Hi everyone,
I am working on a project in which I need to buy an 802.11 a or g radio that can be configured and controlled completely by SPI (serial peripheral interface). Do you have any suggestions for me? It has to be a radio (MAC and PHY only, no TCP/IP stack on top). I...
IP address?
It doesn't. You have to assign one to it. An IP is usually a group of 4 numbers like 10.0.0.9. It is completely up to you to decide which address a device will get. Then you configure your switch or router to handle the routing.
opamp divider
But the gain will be negative. So be careful if your circuit doesn't have reverse protect. I will use the op amp as an adder of two or more other op amps with both inverting and non-inverting gains.
toy car stop exact
What kind of motor are you using? Stepper motor? If yes, you can turn 90 degree by simply rotating only 1 wheel and keep the other one stationary.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
