Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
In general, you can apply and see patterns if you use logic analyzer. But, it depends on your signal conditions, such as votage, slew rate, freq....
I don't think I have general document. I read only manuals if it is needed. Using LA is not hard at all. If you give a try, you will see right...
Hello.
I am a student working on digital VLSI design. I am always wondering if there is any testing board or tool kit that can test my chips. What I usually do is to build a PCB board and socket after I get the packaged chip. And then I use logic analyzer, oscilloscopes and pulse generators to...
spice time varying resistor
Thank you for replying!
I meant the simulation using "Virtuso Analog Design Environment".
I need to run a transient analysis. but I dont know what function or what variable gives the time during the transient analysis.
If I can access the time, then I would be...
transient simulation dc source
Hello.
I want to run a simulation using cadence(icfb). The simulation should show time transient result with a time varing resistor value. Basically, I want to assign the value of resistor as res = sin( w* time) + some offset. Is there any way to do this?
The...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
