Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi again,
I've tries to do some test but it seems the tool doesn't allow me to change default via layer from multilayer to any single layer mode. I've put the hole size to zero and I have also tried to force single layer mode by setting start and layer to the same layer, but that doesn't work...
Mmm, no, it's not a routing problem. Routing is a problem because the footprint ignores same pads with same identifier. Or I can't make it recognize them as a single split pad.
If the footprint would manage the pads as it should there should not be any need for routing the footprint pads to...
Hi,
yes, the intention is to have a footprint that adapts SMD components to thru-hole pads.
I made my footprint in PCB library (my first pic in my previous post). However those footprint are not associated to any net as they are only mechanical footprint that are added to the board but not part...
Thanks for the answer.
Yes, I did. Via is not different than a normal PAD. Still short circuits are reported when using them.
Here an example.
First how the pads have been defined in the footprint editor:
And here the errors reported by the PCB designer
As you can see the only way to not...
Hello,
I have looked for a solution to this problem everywhere, but I could not find any solution.
I am trying to create a custom footprint with some custom pads. These pads are nothing special: they are a joining of 2 elementary pads. One pad is only on the top layer, the second is a...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
