Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi vfone,
Thanks for your reply. I'm actually curious as to why they call it pulling the load. What is it that is being pulled, is what i'm actually looking for. Sorry for not clarifying this a bit more. Am just curious as to why its referred to as pulling the load impedance.
Chris.
Hi folks,
I am curious as to whether someone could actually tell me why load-pull analysis is called load-pull. I have only seen one real statement which states that it involves "varying or 'pulling' the impedance". This statement is not fully clear as to where the word pull finds...
Hi,
I am looking for some help in setting up a serial interface between PIC16F684 and a digital device. Hi-Tech C is new to me so i'm sure this may be a simple task but would like some direction. I need to be able to transmit the below data, see Timing Diagram, and would appreciate if...
stability factor mu
Hi, i have been looking into LNA design in ADS and have come across a design which calculates the K Factor along with B1 parameter and also the Mu factor.
The statement is that K>1 and B1>0 for stability, Mu>1 for stability.
What exactly is the difference between K factor...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
