Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi, I got lot of data in polar form and want to processing by creating a formula/program in matlab. Can anyone give me some advice.I am starter of Matlab.
For example ,
F(x) = [100*(S11)*(S22) + S12]/ S11
And i have lot of data of S11 ,S22 ,S12 in polar form
S11 Magnitude Phase...
This is my summarize.Am i right about the understanding of terminating impedance?
Given: chip impedance = 22-196j
Below is my approach,
Step1) design a pattern on patch antenna to obtain a Z-parameter graph
which (ideal case : antenna impedance = 22+ 195j between 860 to 940MHz)
Step2)...
Thanks for your reply again =)
1)I am confusing about the source impedance and load impedance.
In this case ,
source impedance = chip impedance (22-196j) ?
load impedance = antenna impedance( 22+196j) ?
And i agree with "the ans is you use "complex conjugate" of the impedance that the...
Hi smoothcriminal,
Thanks for your reply and sorry about the clearness of the question.
Now i am going to design a RFID antenna and match the chip impedance which is 22-196j
In IE3D , i want to obtain the S11 graph after simulation.
What should i set in terminating impedance Zc?
I can sure...
Hi all.
I am going to design a antenna to match the chip impedance with 22-196j.
What is the Terminating Impedance Zc i need to set?
Terminating Impedance mean load impedance when calculate S11(Gamma)?
From the equation Gamma = (Zc-Zo)/(Zc+Zo),
where Zc = load impedance = terminating...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
