Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hai all.
I am new to inductor design Please help me to design inductor.
Input voltage = 100v
input current = 3A
inductance L = 613 mH
frequency f = 50 to 200hz
Please help me to find the correct core, number of turns, core area, window area.
thank you all
Hai all
I am new to TL494 PWM generator.
I want following requirements
dead time = 2usec
frequency = 10Khz
Please tell me the Values of RT, CT and explain how to set dead time
tanx....
Hai all....
Please tell me the Core size, core type for following details.
I/p voltage = 230v
I/p current = 2A
VA = 500VA
O/P1 voltage = 100v
O/p1 current = 5 A
O/P2 voltage = 40v
O/p2 current = 1.2 A
tell me type, size , weight of the transformer?
I am not using any drivers, just absorbed wave forms in scope. see the attached image.
pwm switching frequency = 10khz
dead time = 2usec
yellow color = PWM
Blue color = Inverted PWM
Hai all..
I am using LPC1769 to generate PWM with dead time using MCPWM peripheral. The problem is normal PWM is max duty cycle is 48% , inverted PWM should be max duty cycle 48%. But inverted PWM is getting minimum 52% duty cycle. Dead time is 2usec. Can any one help me?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.