Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
An electronics engineer could program (not ofcourse so advanced as a computer engineer) but a computer engineer couldnot design circuits.....
So i vote electronics enginner....
Of course you must do what you love.....
you could use a powe supply voltage supervisor ic like the tl7705 that will produce a programmable pulse when you connect the power. (it was design to give the reset signal) you will AND gate this signal with your clock
Alternatively you can use o CD4541 ic that will drive the AND gate that...
connecting to clock source fpga
Any experiment board should use a clock source.
If your cpld has enaugh flip flops use an integrated crystal oscilator with a frequency between 4MHz and 50MHz, and you will use flip flops to divide it.
In any way you will never use a 555 ic to give clock to...
lm317 20a
Its better to use L200 with external transistors because in most circuits that use lm317 with external transistors there is no current protection for the external transistors.
In L200 with external transistors there is current protection. You will find circuits with L200 in www.st.com...
c8051f340 free c compiler
Atmel AVR microcontrollers are very easy to use (simple programming model) have low cost and you can find them everywhere. Also all AVRs too fast.
So I use the 8515 (at90s8515 -atmega8515), Atmega162, and the 2313.
Also very nice microcontrollers with very flexible...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
