Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by chingtang

  1. C

    Differential amplifier with active load

    active load differential amplifier See chapter 4 in Razavi's book The differential amp is a amp that amplify the diff mode signal and try to reject the common mode signal. The diff amp with active current load is just a way to increase the gain of the diff amp.
  2. C

    What are one-stage Op Amps ?

    One-stage Op Amps Microelectronic Circuit Design, 2/e Richard Jaeger, Auburn University That's where I learn from. good for beginner.
  3. C

    ABOUT unit gain buffer ...

    I think the key difference is the output voltage swing. For telescopic op amp, if you connect the input and output to implement a unity-gain buffer, the output swing is Vth4-(Vgs4-Vth2) [Razavi page 299]. But if you are using a folded cascode op amp, the output swing is higher than the...
  4. C

    What is a MOS differential pair ?

    Re: MOs Differential Pair A differential pair amplifies the differencial signal and rejects the common mode signal. It's chapter 4 in Razavi's book.
  5. C

    How to simulate the power out in amplifier using PSpice?

    Re: Ampifiers If you are using a Orcad Capture, after you run the simulation ,go to "PSpice" -> Bias points -> Enable bias display. Then look at the number on top of your power supply.
  6. C

    How to learn Analog Circuit Design?

    Try Microelectronic Circuit Design, 2/e Richard Jaeger, Auburn University. That's good for the beginners.b
  7. C

    How to run/generate netlist at Orcad PSpice[win]

    How to run/generate netlist at Orcad PSpice[win]? Also, is there a way that we can generate our own symbol? Thanks
  8. C

    Optimization Models for Decision Making

    Optimization Models for Decision Making By Katta G. Murty **broken link removed** Computational and Algorithmic Linear Algebra and n-Dimensional Geometry By Katta G. Murty **broken link removed**
  9. C

    Lumped Circuit Element

    You may want to read "Lumped Elements for RF and Microwave Circuits" by Inder Bahl for more detail.
  10. C

    how to learn rf ic design

    The Design of Analog CMOS Integrated Circuits by Razavi and Microwave Engineering by Pozar should be a good start for people like me interesting in RF design.
See more

Part and Inventory Search

Back
Top