Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I am trying to connect JTAG to MIPS 24Kc SoC which has 8 pin out of the board. The pins are- TRST, TCK, GND, TMS, TDI, VCC, TDO, RST. My JTAG device is FTDI2332 based, 20 pin, ARM-USB-OCD from Olimex. The router's onboard Vcc pin (jtag) is 3.3v when JTAG debugger's Vcc is 5v. Unlike the 20 pin...
Hi,
I'm trying to reuse some old unused LAN cards to connect to some microcontroller evaluation boards with ethernet support. I chopped off the PHY while keeping the rest. I am treating the RJ-45 to PHY circuitry as blackbox, while dealing with the wires coming out the transformer connecting...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
