Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
shaiko, thanks for replying. i will be using **broken link removed**
Can I use Arduino development board for this project. I am a vlsi chip designing student and very new to all this. This project is silly but I want to make it work :D
MSP430 has input voltage range of 1.8-3.6V and laser...
thank you jayanth for all these links. I have gone through them before. First one is IR laser, i need visible light one for safety.
iC-HT is a wonderful product but it is just a driver i need to interface uC with it. will msp430 be ok? also it has very less online support, if i am stuck i have...
Alright. let me explain the whole system.
I am trying to build a system in which there is a transmitter and a receiver. transmitter will send a signal via rf tx and fr rx receives and passes signal to uC and this turns on laser module. Now laser module has to be high powered laser because...
Hi !
I want to turn on a 405nm, 150mW laser diode using a microcontroller. Can anybody suggest me which uC will be best to do this function?
Also if i use MSP430 launchpad to receive RF signal and turn on laser diode with laser driver circuit attached to it, is this feasible?
Thank you so much newtonoid !! :D
That is so awesome. That pair is really dirt cheap !! My purpose is to just turn on laser using a transmitter at some distance so I think this should work.
Also I am new to this wireless functionality programming so it would be awesome if you could send me...
Hey thank you for the reply.
I was thinking of using Zigbee TX and RX pair with MSP430 microcontroller to do the job of turning on a laser. Is it feasible?
i am trying to make a circuit with laser diode on receiver.
I want the laser to turn on when receiver receives the signal. Also I want at least 100 ft distance between both TX and RX.
This is my first time so I have a whole bunch of questions:
1. Laser diode: does it need a driver always? Can I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
