Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi,
To see linear polarization E plane result > Far field report > radiation pattern
set theta = all , phi = 0
gain, in category select gain phi n theta both.
same step to H plane only set phi = 90.
hi,
To see linear polarization E plane result > Far field report > radiation pattern
set theta = all , phi = 0
gain, in category select gain phi n theta both.
same step to H plane only set phi = 90.
Hi WimRFP,
whatever you say i understand that, but i have refered many paper in that For E field co & cross polarization (means vertical & horizantal ) are plotted in same graph.For H field the same way. as im following your procedure im getting 2 different graphs.
plz tell me where im wrong ...
can u plz solve my issue? im confused for E plane what is co & cross. becz u say 4 E & H plane gain phi & gain theta respectively . then wher is E plane co & cross ploz? n H also
hi frodonet,
actualy i amgetting confused what steps should be used to see E-plane & H plane polarization. bcz in circular it gives direct LHCP & RHCP. but foe linear which parameter should select??????????
NO, i havent got my solution.
please, suggest its solution.
i changed inf_gnd to gnd so, im getting complete graph. but nt able to differentiate which is co and cross polarization.
hi,
today i get more confused. i was designed on square MSA.when i am using below method at that time phi= theta so i thought its circular, but when i check its axial ratio its above 3 dB that means linear.
so, wt shall i consider this linear or circular ?
thanks
hi,
is it means for selecting gain Vs freq plot phi and theta should be all ? I have assigned infinite sphere for theta = -180 to 180, and phi 0 to 90.
1) shall i take both values 0 every time to plot the graph ?
2) which gain value should be selected which gives max gain or for the...
yes i have assigned radiation boundary & infinite sphere too. but didnt get results.
and 1 more height of GND plane affect on polarization ? if yes what should its value.
Thanking u in anticipation
Thanks Jeeudar.
for checking should setup on Last Adaptive ??
im attaching the file 4m which i get the results,from this i can say its circular polarization.
actually i want linear polarization, due to slot in center position i get circular polarization.
i have read thread which u refered...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
